NFORCE2-U400R: 00:09.0 (rev a3) UDMA133 controller ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:DMA ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA HPT370: IDE controller at PCI slot 01:09.0 HPT370: chipset revision 3 HPT370: not 100% native mode: will probe irqs later HPT37X: using 33MHz PCI clock ide2: BM-DMA at 0xd700-0xd707, BIOS settings: hde:DMA, hdf:DMA ide3: BM-DMA at 0xd708-0xd70f, BIOS settings: hdg:DMA, hdh:DMA HPT370: IDE controller at PCI slot 01:0b.0 HPT370: chipset revision 3 HPT370: not 100% native mode: will probe irqs later HPT37X: using 33MHz PCI clock ide4: BM-DMA at 0xdc00-0xdc07, BIOS settings: hdi:pio, hdj:pio ide5: BM-DMA at 0xdc08-0xdc0f, BIOS settings: hdk:pio, hdl:pio hda: WDC WD2500JB-00EVA0, ATA DISK drive hdb: Maxtor 7Y250P0, ATA DISK drive blk: queue c03b6f20, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b705c, I/O limit 4095Mb (mask 0xffffffff) hdc: ST3250823A, ATA DISK drive hdd: HDS722525VLAT80, ATA DISK drive blk: queue c03b7374, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b74b0, I/O limit 4095Mb (mask 0xffffffff) hde: ST3250823A, ATA DISK drive hdf: ST3250823A, ATA DISK drive blk: queue c03b77c8, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b7904, I/O limit 4095Mb (mask 0xffffffff) hdg: ST3120026A, ATA DISK drive hdh: ST3160023A, ATA DISK drive blk: queue c03b7c1c, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b7d58, I/O limit 4095Mb (mask 0xffffffff) hdi: IC35L120AVVA07-0, ATA DISK drive hdj: WDC WD1200BB-00CAA1, ATA DISK drive blk: queue c03b8070, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b81ac, I/O limit 4095Mb (mask 0xffffffff) hdk: IC35L120AVV207-1, ATA DISK drive hdl: WDC WD1200PB-00FBA0, ATA DISK drive blk: queue c03b84c4, I/O limit 4095Mb (mask 0xffffffff) blk: queue c03b8600, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 ide1 at 0x170-0x177,0x376 on irq 15 ide2 at 0xd300-0xd307,0xd402 on irq 7 ide3 at 0xd500-0xd507,0xd602 on irq 7 ide4 at 0xd800-0xd807,0xd902 on irq 5 ide5 at 0xda00-0xda07,0xdb02 on irq 5 hda: attached ide-disk driver. hda: host protected area => 1 hda: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(100) hdb: attached ide-disk driver. hdb: host protected area => 1 hdb: setmax_ext LBA 490234752, native 490232639 hdb: 490232639 sectors (250999 MB) w/7936KiB Cache, CHS=30515/255/63, UDMA(133) hdc: attached ide-disk driver. hdc: host protected area => 1 hdc: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(100) hdd: attached ide-disk driver. hdd: host protected area => 1 hdd: 488397168 sectors (250059 MB) w/7938KiB Cache, CHS=30401/255/63, UDMA(100) hde: attached ide-disk driver. hde: host protected area => 1 hde: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(100) hdf: attached ide-disk driver. hdf: host protected area => 1 hdf: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63, UDMA(100) hdg: attached ide-disk driver. hdg: host protected area => 1 hdg: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=14593/255/63, UDMA(100) hdh: attached ide-disk driver. hdh: host protected area => 1 hdh: 312581808 sectors (160042 MB) w/8192KiB Cache, CHS=19457/255/63, UDMA(100) hdi: attached ide-disk driver. hdi: host protected area => 1 hdi: 241254720 sectors (123522 MB) w/1863KiB Cache, CHS=239340/16/63, UDMA(100) hdj: attached ide-disk driver. hdj: host protected area => 1 hdj: 234441648 sectors (120034 MB) w/2048KiB Cache, CHS=232581/16/63, UDMA(100) hdk: attached ide-disk driver. hdk: host protected area => 1 hdk: 241254720 sectors (123522 MB) w/7965KiB Cache, CHS=15017/255/63, UDMA(100) hdl: attached ide-disk driver. hdl: host protected area => 1 hdl: 234441648 sectors (120034 MB) w/8192KiB Cache, CHS=14593/255/63, UDMA(100) Partition check: hda: hda1 hda2 hda3 hdb: hdb1 hdc: hdc1 hdd: hdd1 hde: hde1 hdf: hdf1 hdg: hdg1 hdh: hdh1 hdi: [PTBL] [15017/255/63] hdi1 hdj: [PTBL] [14593/255/63] hdj1 hdk: hdk1 hdl: hdl1 SCSI subsystem driver Revision: 1.00 libata version 1.11 loaded. sata_nv version 0.6 PCI: Setting latency timer of device 00:0b.0 to 64 ata1: SATA max UDMA/133 cmd 0x9F0 ctl 0xBF2 bmdma 0xE900 irq 11 ata2: SATA max UDMA/133 cmd 0x970 ctl 0xB72 bmdma 0xE908 irq 11 ata1: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3469 86:3c01 87:4003 88:407f ata1: dev 0 ATA, max UDMA/133, 390721968 sectors: lba48 ata1: dev 0 configured for UDMA/133 ata2: dev 0 cfg 49:2f00 82:346b 83:7d01 84:4003 85:3469 86:3c01 87:4003 88:407f ata2: dev 0 ATA, max UDMA/133, 390721968 sectors: lba48 ata2: dev 0 configured for UDMA/133 scsi0 : sata_nv scsi1 : sata_nv Vendor: ATA Model: ST3200822AS Rev: 3.01 Type: Direct-Access ANSI SCSI revision: 05 Vendor: ATA Model: ST3200822AS Rev: 3.01 Type: Direct-Access ANSI SCSI revision: 05 Attached scsi disk sda at scsi0, channel 0, id 0, lun 0 Attached scsi disk sdb at scsi1, channel 0, id 0, lun 0 SCSI device sda: 390721968 512-byte hdwr sectors (200050 MB) sda: sda1 sda2 sda3 SCSI device sdb: 390721968 512-byte hdwr sectors (200050 MB) sdb: sdb1 |