Изпечатай

[angie_bg]

Случаят е пълна илюстрация на синдрома "Ама то вчера си работеше...": след нормално отмонтиране на единия ден, на другия флашката се разпознава, но не може да се монтира. Qparted информира, че няма партиция на носителя (raw), но не може да я създаде наново. Безуспешно бе и използването на Partition Magic под Windows. Някакви идеи за спасяването на флашката или да я дам за скрап?

[Activity]

като я монтираш какво ди тава "dmesg" ? , ако я монтира правилно значи може лесно да се форматира по какъвто искаш начин , аз имаш проблем с една таква kingston и проблема накрая беше чисто хардуерен '>

[angie_bg]

Изходът от dmesg (в частта, касаеща USB) е:

Цитат

[    0.000000] Linux version 2.6.20-15-386 (root@palmer) (gcc version 4.1.2 (Ubuntu 4.1.2-0ubuntu4)) #2 Sun Apr 15 07:34:00 UTC 2007 (Ubuntu 2.6.20-15.27-386) .... [13528.376000] hub 1-0:1.0: over-current change on port 1 [13528.720000] usb 1-1: new full speed USB device using uhci_hcd and address 2 [13528.892000] usb 1-1: configuration #1 chosen from 1 choice [13530.808000] usbcore: registered new interface driver libusual [13531.012000] Initializing USB Mass Storage driver... [13531.016000] scsi0 : SCSI emulation for USB Mass Storage devices [13531.092000] usb-storage: device found at 2 [13531.092000] usb-storage: waiting for device to settle before scanning [13531.092000] usbcore: registered new interface driver usb-storage [13531.092000] USB Mass Storage support registered. [13536.092000] usb-storage: device scan complete [13536.096000] scsi 0:0:0:0: Direct-Access              USB DISK 2.0     PMAP PQ: 0 ANSI: 0 CCS [13539.372000] SCSI device sda: 2015232 512-byte hdwr sectors (1032 MB) [13539.376000] sda: Write Protect is off [13539.376000] sda: Mode Sense: 23 00 00 00 [13539.376000] sda: assuming drive cache: write through [13539.388000] SCSI device sda: 2015232 512-byte hdwr sectors (1032 MB) [13539.392000] sda: Write Protect is off [13539.392000] sda: Mode Sense: 23 00 00 00 [13539.392000] sda: assuming drive cache: write through [13539.392000]  sda: sda1 [13539.396000] sd 0:0:0:0: Attached scsi removable disk sda [13539.440000] sd 0:0:0:0: Attached scsi generic sg0 type 0 [13910.412000] usb 1-1: USB disconnect, address 2 [13928.108000] hub 1-0:1.0: over-current change on port 1 [13928.452000] usb 1-1: new full speed USB device using uhci_hcd and address 3 [13928.612000] usb 1-1: configuration #1 chosen from 1 choice [13928.616000] scsi1 : SCSI emulation for USB Mass Storage devices [13928.616000] usb-storage: device found at 3 [13928.616000] usb-storage: waiting for device to settle before scanning [13933.616000] usb-storage: device scan complete [13933.620000] scsi 1:0:0:0: Direct-Access     USB 2.0  Flash Disk       0.00 PQ: 0 ANSI: 2 [13933.624000] sda : very big device. try to use READ CAPACITY(16). [13933.624000] sda : READ CAPACITY(16) failed. [13933.624000] sda : status=0, message=00, host=5, driver=00 [13933.624000] sda : use 0xffffffff as device size [13933.624000] SCSI device sda: 4294967296 512-byte hdwr sectors (2199023 MB) [13933.628000] sda: Write Protect is off [13933.628000] sda: Mode Sense: 00 00 00 00 [13933.628000] sda: assuming drive cache: write through [13933.636000] sda : very big device. try to use READ CAPACITY(16). [13933.636000] sda : READ CAPACITY(16) failed. [13933.636000] sda : status=0, message=00, host=5, driver=00 [13933.636000] sda : use 0xffffffff as device size [13933.636000] SCSI device sda: 4294967296 512-byte hdwr sectors (2199023 MB) [13933.636000] sda: Write Protect is off [13933.636000] sda: Mode Sense: 00 00 00 00 [13933.636000] sda: assuming drive cache: write through [13933.636000]  sda:end_request: I/O error, dev sda, sector 0 [13933.644000] Buffer I/O error on device sda, logical block 0 [13933.652000] end_request: I/O error, dev sda, sector 0 [13933.652000] Buffer I/O error on device sda, logical block 0 [13933.656000] end_request: I/O error, dev sda, sector 0 [13933.656000] Buffer I/O error on device sda, logical block 0 [13933.664000] end_request: I/O error, dev sda, sector 0 [13933.664000] Buffer I/O error on device sda, logical block 0 [13933.672000] end_request: I/O error, dev sda, sector 0 [13933.672000] Buffer I/O error on device sda, logical block 0 [13933.672000] ldm_validate_partition_table(): Disk read failed. [13933.680000] end_request: I/O error, dev sda, sector 0 [13933.680000] Buffer I/O error on device sda, logical block 0 [13933.684000] end_request: I/O error, dev sda, sector 0 [13933.684000] Buffer I/O error on device sda, logical block 0 [13933.692000] end_request: I/O error, dev sda, sector 0 [13933.692000] Buffer I/O error on device sda, logical block 0 [13933.700000] end_request: I/O error, dev sda, sector 0 [13933.700000] Buffer I/O error on device sda, logical block 0 [13933.700000] Dev sda: unable to read RDB block 0 [13933.708000] end_request: I/O error, dev sda, sector 0 [13933.708000] Buffer I/O error on device sda, logical block 0 [13933.712000] end_request: I/O error, dev sda, sector 0 [13933.720000] end_request: I/O error, dev sda, sector 24 [13933.728000] end_request: I/O error, dev sda, sector 24 [13933.736000] end_request: I/O error, dev sda, sector 0 [13933.736000]  unknown partition table [13933.736000] sd 1:0:0:0: Attached scsi removable disk sda [13933.736000] sd 1:0:0:0: Attached scsi generic sg0 type 0 [13934.796000] end_request: I/O error, dev sda, sector 4294967168 [13934.800000] end_request: I/O error, dev sda, sector 4294967168 [13934.808000] end_request: I/O error, dev sda, sector 4294967288 [13934.848000] end_request: I/O error, dev sda, sector 4294967288 [13934.868000] end_request: I/O error, dev sda, sector 4294967288 [13934.872000] end_request: I/O error, dev sda, sector 4294967288 [13934.880000] end_request: I/O error, dev sda, sector 4294967288 [13934.888000] end_request: I/O error, dev sda, sector 4294967288 [13934.908000] end_request: I/O error, dev sda, sector 4294967232 [13934.912000] end_request: I/O error, dev sda, sector 4294967280 [13934.920000] end_request: I/O error, dev sda, sector 4294967288 [13934.928000] end_request: I/O error, dev sda, sector 4294967288 [13934.936000] end_request: I/O error, dev sda, sector 0 [13934.940000] end_request: I/O error, dev sda, sector 0 [13934.948000] end_request: I/O error, dev sda, sector 0 [13934.956000] end_request: I/O error, dev sda, sector 0 [13934.968000] end_request: I/O error, dev sda, sector 0 [13934.976000] end_request: I/O error, dev sda, sector 0 [13934.984000] end_request: I/O error, dev sda, sector 0 [13934.992000] end_request: I/O error, dev sda, sector 0 [13935.000000] end_request: I/O error, dev sda, sector 0 [13935.004000] end_request: I/O error, dev sda, sector 0 [13935.012000] end_request: I/O error, dev sda, sector 0 [13935.020000] end_request: I/O error, dev sda, sector 0 [13935.028000] end_request: I/O error, dev sda, sector 0 [13935.036000] end_request: I/O error, dev sda, sector 0 [13935.044000] end_request: I/O error, dev sda, sector 0 [13935.052000] end_request: I/O error, dev sda, sector 0 [13935.060000] end_request: I/O error, dev sda, sector 0 [13935.064000] end_request: I/O error, dev sda, sector 0 [13935.072000] end_request: I/O error, dev sda, sector 0 [13935.080000] end_request: I/O error, dev sda, sector 0 [13935.088000] end_request: I/O error, dev sda, sector 0 [13935.092000] end_request: I/O error, dev sda, sector 0 [13935.100000] end_request: I/O error, dev sda, sector 0 [13935.108000] end_request: I/O error, dev sda, sector 0 [13935.116000] end_request: I/O error, dev sda, sector 0 [13935.124000] end_request: I/O error, dev sda, sector 0 [13935.132000] end_request: I/O error, dev sda, sector 0 [13935.140000] end_request: I/O error, dev sda, sector 0

С X-Edit (под Windows) опитах да записвам 0 (нули) в първите сектори, но безуспешно. Явно става дума за хардуерен дефект.

[spirtbrat]

Еми, пробвай я на друг компютър щом се съмняваш за хардуерен дефект. Ако и там не работи, пробвай да и сложиш по-нов firmware. Ако няма по-нов, просто преинсталирай текущия. Ако и след това не работи нито на твоя компютър, нито на някой друг, тогава можеш да я дадеш за скрап '>

[Todir]

А с fdisk или cfdisk пробва ли да я оправиш? Никога не съм се занимавал с усб флкашки, но преди няколко дена една микросд крта ми скъса нервите по същия начин, даже в win нито една програма не можа да я разпознае. Оправи се като изтрих старите дялов и създаох нов. Всъщност само fdisk успя да ми помогне. Пробвай, може да върже...

[angie_bg]

Решен:

Направих доста проби, под Linux и Windows, но безуспешно - докато не попаднах на JetFlash Recovery Tools (Windows) - руска програмка, която успешно успя да възстанови флашката. Единственият страничен ефект е, че под Windows се разпознава като JetFlash устройство.