При lilo -C /etc/lilo.conf става тази красота
Warning:LBA32 addressing assumed
Warning: '/proc/partitons does not exist disk scan bypassed
Fatal:Linux experimental device 0x04x needs to be defined
След рестарт същата работа
А относно диск той е само един
sda1 = boot
sda2 = root
eто и лилото 
добавяш на първия ред lba32 в lilo.conf
# LILO configuration file
# generated by 'liloconfig'
#
# Start LILO global section
# Append any additional kernel parameters:
lba32
append=" vt.default_utf8=1 acpi_enforce_resources=lax"
boot = /dev/sda
# Boot BMP Image.
# Bitmap in BMP format: 640x480x8
# bitmap = /boot/slack.bmp
bitmap = /boot/slack.bmp
# Menu colors (foreground, background, shadow, highlighted
# foreground, highlighted background, highlighted shadow):
bmp-colors = 255,0,255,0,255,0
# Location of the option table: location x, location y, number of
# columns, lines per column (max 15), "spill" (this is how many
# entries must be in the first column before the next begins to
# be used. We don't specify it here, as there's just one column.
bmp-table = 60,6,1,16
# Timer location x, timer location y, foreground color,
# background color, shadow color.
bmp-timer = 65,27,0,255
# Standard menu.
# Or, you can comment out the bitmap menu above and
# use a boot message with the standard menu:
#message = /boot/boot_message.txt
# Wait until the timeout to boot (if commented out, boot the
# first entry immediately):
prompt
# Timeout before the first entry boots.
# This is given in tenths of a second, so 600 for every minute:
timeout = 70
# Override dangerous defaults that rewrite the partition table:
change-rules
reset
#vga = 775
# VESA framebuffer console @ 1024x768x256
#vga = 773
# Normal VGA console
vga = normal
# VESA framebuffer console @ 1024x768x64k
# vga=791
# VESA framebuffer console @ 1024x768x32k
# vga=790
# VESA framebuffer console @ 1024x768x256
# vga=773
# VESA framebuffer console @ 800x600x64k
# vga=788
# VESA framebuffer console @ 800x600x32k
# vga=787
# VESA framebuffer console @ 800x600x256
# vga=771
# VESA framebuffer console @ 640x480x64k
# vga=785
# VESA framebuffer console @ 640x480x32k
# vga=784
# VESA framebuffer console @ 640x480x256
# vga=769
# End LILO global section
# Linux bootable partition config begins
image = /boot/vmlinuz
root = /dev/sda2
label = Slackware
read-only
# Linux bootable partition config ends
За повече информация man lilo
По лесно е да зададеш въпрос и да получиш отговор отколкото да си потърсиш отговора сам в чичко гугле има всичко и да почетеш малко! Това са елементарни работи щом си го криптнал диска предполага се че можеш да се оправиш с едно lilo май ви мързи да четете.
Покажи Публикации - Желязко Желязков
![[_]3](https://www.linux-bg.org/forum/Smileys/default/beer.gif "Beer")
