|
Титла: Mrtg на двупроцесорна машина Публикувано от: Bogo в Jul 14, 2007, 20:03 Машината е PowerEdge 2500
Ето линк какво показва. Времето върви и черта на 0%. Мисля че проблема е в snmp но не съм сигурен. процесори: ------------------------------------------------------------------------- *-cpu:0 description: CPU product: Pentium III (Coppermine) vendor: Intel Corp. physical id: 400 bus info: cpu@0 version: 6.8.10 slot: Proc_1 size: 1GHz capacity: 1533MHz width: 32 bits clock: 133MHz capabilities: fpu fpu_exception wp vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov pat pse36 mmx fxsr sse *-cache:0 description: L1 cache physical id: 700 size: 32KB capacity: 32KB capabilities: internal write-back *-cache:1 description: L2 cache physical id: 701 size: 256KB capacity: 2MB capabilities: pipeline-burst internal write-back unified *-cpu:1 description: CPU product: Pentium III (Coppermine) vendor: Intel Corp. physical id: 401 bus info: cpu@1 version: 6.8.10 slot: Proc_2 size: 1GHz capacity: 1533MHz width: 32 bits clock: 133MHz capabilities: fpu fpu_exception wp vme de pse tsc msr pae mce cx8 apic sep mtrr pge mca cmov pat pse36 mmx fxsr sse *-cache:0 description: L1 cache physical id: 702 size: 32KB capacity: 32KB capabilities: internal write-back *-cache:1 description: L2 cache physical id: 703 size: 256KB capacity: 2MB capabilities: pipeline-burst internal write-back unified ------------------------------------------------------------------------------------------ ------- ето и cpu.cfg ------------------------------------------------------------------------------------------ ------ WorkDir: /home/www/mrtg LoadMIBs: /usr/share/snmp/mibs/UCD-SNMP-MIB.txt Target[localhost.cpu]:ssCpuRawUser.0&ssCpuRawUser.0:public@127.0.0.1+ ssCpuRawSystem.0&ssCpuRawSystem.0:public@127.0.0.1+ ssCpuRawNice.0&ssCpuRawNice.0:public@127.0.0.1 RouterUptime[localhost.cpu]: public@127.0.0.1 MaxBytes[localhost.cpu]: 100 Title[localhost.cpu]: CPU Load PageTop[localhost.cpu]: <H1>Active CPU Load %</H1> Unscaled[localhost.cpu]: ymwd ShortLegend[localhost.cpu]: % YLegend[localhost.cpu]: CPU Utilization Legend1[localhost.cpu]: Active CPU in % (Load) Legend2[localhost.cpu]: Legend3[localhost.cpu]: Legend4[localhost.cpu]: LegendI[localhost.cpu]: Active LegendO[localhost.cpu]: Options[localhost.cpu]: growright,nopercent,gauge ---------------------------------------------------------------------------------- Някой да има идея как мога да го накарам да показва? |