Linux за българи: Форуми

Linux секция за начинаещи => Настройка на програми => Темата е започната от: mrowcp в May 11, 2010, 12:26



Титла: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: mrowcp в May 11, 2010, 12:26
Не знам дали точно тук е мястото, но какво точно означават тези два термина.
До колко прочетох 1вото има два параметъра - Frame Retry Rate – High Watermark и
Frame Retry Rate –Low watermark, но не захапах какви трябва да са им стойностите за да не бълва тази грешка.
Второто е ясно, че е нещо за скороста, ама... само толкова :)
Мерси


Титла: Re: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: romeo_ninov в May 11, 2010, 12:42
Цитат
The High Watermark refers to the percentage threshold, which if surpassed triggers the event that causes the trap to be sent. The Low Watermark refers to the percentage threshold, such that if the retry rate reaches a value lower than this value the event is reset. The trap will be triggered the first time the Frame Retry rate crosses the High Watermark and then will only be triggered if the Frame Retry Rate goes under the Low Watermark and then crosses the High Watermark again. This holds true for the bandwidth rate and low speed rate thresholds as well.


Титла: Re: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: mrowcp в May 11, 2010, 13:05
Цитат
The High Watermark refers to the percentage threshold, which if surpassed triggers the event that causes the trap to be sent. The Low Watermark refers to the percentage threshold, such that if the retry rate reaches a value lower than this value the event is reset. The trap will be triggered the first time the Frame Retry rate crosses the High Watermark and then will only be triggered if the Frame Retry Rate goes under the Low Watermark and then crosses the High Watermark again. This holds true for the bandwidth rate and low speed rate thresholds as well.

Да това го знам, въпроса е че при превода не мога да схвана смисъла.Иначе pdf-a е добър ;)


Титла: Re: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: romeo_ninov в May 11, 2010, 13:30
Цитат
The High Watermark refers to the percentage threshold, which if surpassed triggers the event that causes the trap to be sent. The Low Watermark refers to the percentage threshold, such that if the retry rate reaches a value lower than this value the event is reset. The trap will be triggered the first time the Frame Retry rate crosses the High Watermark and then will only be triggered if the Frame Retry Rate goes under the Low Watermark and then crosses the High Watermark again. This holds true for the bandwidth rate and low speed rate thresholds as well.

Да това го знам, въпроса е че при превода не мога да схвана смисъла.Иначе pdf-a е добър ;)
имап две числа (ниско и високо), ако броя на пакетите за секунда е под ниското няма аларма, ако мине високото има аларма докато не слезе под ниския. какво не е ясно


Титла: Re: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: mrowcp в May 11, 2010, 13:44
Цитат
The High Watermark refers to the percentage threshold, which if surpassed triggers the event that causes the trap to be sent. The Low Watermark refers to the percentage threshold, such that if the retry rate reaches a value lower than this value the event is reset. The trap will be triggered the first time the Frame Retry rate crosses the High Watermark and then will only be triggered if the Frame Retry Rate goes under the Low Watermark and then crosses the High Watermark again. This holds true for the bandwidth rate and low speed rate thresholds as well.

Да това го знам, въпроса е че при превода не мога да схвана смисъла.Иначе pdf-a е добър ;)
имап две числа (ниско и високо), ако броя на пакетите за секунда е под ниското няма аларма, ако мине високото има аларма докато не слезе под ниския. какво не е ясно

Аха:) а ако броя пакети за секунда мине над ниското какво става  ;D ?Или той си е там, просто ниското е за граница при която трябва да се върне, при положение, че надвиши високото?
По скоро ме интересува кога дропи?Проблема е, че както е закачен лаптоп-а през определен интервал от време, мрежата изчезва, след което пак се оправя, без да дропи wireless връзката.Ако правилно съм разбрал, трябва да дигна високото ( по-малко да мрънка ) или ниското ( по-бързо да се връща в нормален режим ).


Титла: Re: Frame Retry Rate Exceeded и Frame Low Speed Rate Exceeded
Публикувано от: romeo_ninov в May 11, 2010, 13:54
Не. В момент нула броя на пакетите с retry флаг е нула. Тогава няма аларма. Започва да расте (броя) и минава горната граница, тогава се вдига алармата. В следващ момент започва да слиза надолу и се изключва чак когато мине под долната граница. От тук нататък се следва това правило. А какви трябва да са конкретните стойности зависи от много неща