Титла: USB Mass Storage
Публикувано от: _nmk в Feb 25, 2003, 08:57
repost ot dir.bg:
Zdrawejte,
Opitwam se da pusna kamerata si (Mustek MDC 3500).
Ot /etc/fstab:
/dev/sda1 /mnt/camera vfat noauto,sync,nosuid,user,unhide 0 0
Ot message log:
Feb 24 19:48:44 Yana kernel: hub.c: USB new device connect on bus1/1, assigned device number 2
266 Feb 24 19:48:44 Yana kernel: usb.c: USB device 2 (vend/prod 0x55f/0xc233) is not claimed by any active driver.
267 Feb 24 19:48:47 Yana /etc/hotplug/usb.agent: Setup usb-storage for USB product 55f/c233/100
268 Feb 24 19:48:47 Yana kernel: Initializing USB Mass Storage driver...
269 Feb 24 19:48:47 Yana kernel: usb.c: registered new driver usb-storage
270 Feb 24 19:48:47 Yana kernel: scsi1 : SCSI emulation for USB Mass Storage devices
271 Feb 24 19:48:47 Yana kernel: Vendor: USB Model: Device Rev: 1.00
272 Feb 24 19:48:47 Yana kernel: Type: Direct-Access ANSI SCSI revision: 02
273 Feb 24 19:48:47 Yana kernel: USB Mass Storage support registered.
274 Feb 24 19:49:19 Yana kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
275 Feb 24 19:49:19 Yana kernel: SCSI device sda: 32768 512-byte hdwr sectors (17 MB)
276 Feb 24 19:49:19 Yana kernel: sda: test WP failed, assume Write Enabled
277 Feb 24 19:49:19 Yana kernel: sda: sda1
278 Feb 24 19:49:19 Yana kernel: SCSI device (ioctl) reports ILLEGAL REQUEST.
279 Feb 24 19:49:19 Yana kernel: SCSI device sda: 32768 512-byte hdwr sectors (17 MB)
280 Feb 24 19:49:19 Yana kernel: sda: test WP failed, assume Write Enabled
281 Feb 24 19:49:19 Yana kernel: sda: I/O error: dev 08
0, sector 0
282 Feb 24 19:49:19 Yana kernel: I/O error: dev 080, sector 0
283 Feb 24 19:49:19 Yana kernel: unable to read partition table
Ochewidno posledniqt red sochi greshkata. Kakwo mozhe da se naprawi? Suobshtenieto na mount e, che ne mozhe da nameri valid block device...
I kogato q swurzha i kogato q otkacha, flopito se opitwa da chete... Stranna rabota....
Mnogo blagodarq predwaritelno,
_nmk
Zdrawejte,
Opitwam se da pusna kamerata si (Mustek MDC 3500).
Ot /etc/fstab:
/dev/sda1 /mnt/camera vfat noauto,sync,nosuid,user,unhide 0 0
Ot message log:
Feb 24 19:48:44 Yana kernel: hub.c: USB new device connect on bus1/1, assigned device number 2
266 Feb 24 19:48:44 Yana kernel: usb.c: USB device 2 (vend/prod 0x55f/0xc233) is not claimed by any active driver.
267 Feb 24 19:48:47 Yana /etc/hotplug/usb.agent: Setup usb-storage for USB product 55f/c233/100
268 Feb 24 19:48:47 Yana kernel: Initializing USB Mass Storage driver...
269 Feb 24 19:48:47 Yana kernel: usb.c: registered new driver usb-storage
270 Feb 24 19:48:47 Yana kernel: scsi1 : SCSI emulation for USB Mass Storage devices
271 Feb 24 19:48:47 Yana kernel: Vendor: USB Model: Device Rev: 1.00
272 Feb 24 19:48:47 Yana kernel: Type: Direct-Access ANSI SCSI revision: 02
273 Feb 24 19:48:47 Yana kernel: USB Mass Storage support registered.
274 Feb 24 19:49:19 Yana kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0
275 Feb 24 19:49:19 Yana kernel: SCSI device sda: 32768 512-byte hdwr sectors (17 MB)
276 Feb 24 19:49:19 Yana kernel: sda: test WP failed, assume Write Enabled
277 Feb 24 19:49:19 Yana kernel: sda: sda1
278 Feb 24 19:49:19 Yana kernel: SCSI device (ioctl) reports ILLEGAL REQUEST.
279 Feb 24 19:49:19 Yana kernel: SCSI device sda: 32768 512-byte hdwr sectors (17 MB)
280 Feb 24 19:49:19 Yana kernel: sda: test WP failed, assume Write Enabled
281 Feb 24 19:49:19 Yana kernel: sda: I/O error: dev 08
0, sector 0282 Feb 24 19:49:19 Yana kernel: I/O error: dev 08
0, sector 0283 Feb 24 19:49:19 Yana kernel: unable to read partition table
Ochewidno posledniqt red sochi greshkata. Kakwo mozhe da se naprawi? Suobshtenieto na mount e, che ne mozhe da nameri valid block device...
I kogato q swurzha i kogato q otkacha, flopito se opitwa da chete... Stranna rabota....
Mnogo blagodarq predwaritelno,
_nmk
Титла: USB Mass Storage
Публикувано от: mironcho в Mar 01, 2003, 16:28
# modprobe usb-storage
# mount -t auto /dev/sda1 /mnt/camera
Аз във fstab съм написал:
/dev/sda1 /mnt/usbcam auto users 0 0
Трябва и да си пъхнал всички кабели де
# mount -t auto /dev/sda1 /mnt/camera
Аз във fstab съм написал:
/dev/sda1 /mnt/usbcam auto users 0 0
Трябва и да си пъхнал всички кабели де