Linux за българи: Форуми

Distro: Ubuntu 5.04 Hoary
Izvinete za latinicata no prosto nqmam izbor.
Problema e sledniq:
Imam Wireless karta s chipset rt2500.Dirih iz neta HowTo za instalaciq pod ubuntu 5.04 i namerih kakwoto mi trqbwashe.No iznikna problem pri kompilaciqta na drayvera.Kato napisha "make" (sled kato sum vlqzul s root) i mi izpiswa slednoto:
make{1}:Entering directory '/lib/modules/2.6.10-5-386/build'
make{1}:***No rule to make target 'modules'.Stop
make{1}Leaving directory '/lib/modules/2.6.10-5-386/build'
rt2500.ko failed to build
make:***{module} error 1
Ako nqkoy moje da mi pomogne da resha problema shte sum mu blagodaren.

Вероятно нямаш инсталирани headers на ядрото. Нямам представа как се казват под Убунту
Потърси ги с
apt-cache search kernel-image headers

Hello. After compiling the source for rt2561 from http://svn.openfoundry.org/usert2500/ with original Makefile (because make.serialmonkey is just for 2.6.x kernel) I have these messeges and no connection with the AP. What am I missing? Thank you.

# uname -a
Linux linux 2.4.29 #6 Tue Dec 13 16:30:37 PST 2005 i686 Slackware 10.1 GNU/Linux

#modprobe rt2561
Warning: loading /lib/modules/2.4.29/kernel/drivers/net/wireless/rt2561.o will taint the kernel: no license
See http://www.tux.org/lkml/#export-tainted for information about tainted modules
Module rt2561 loaded, with warnings

#dmesg
PCI: Found IRQ 7 for device 00:0f.0
PCI: Sharing IRQ 7 with 00:11.0

#lspci
00:11.0 Ethernet controller: 3Com Corporation 3c905C-TX/TX-M [Tornado] (rev 6c)
00:0f.0 Network controller: RaLink Ralink RT2600 802.11 MIMO
(Here I have conflict. They are on the same IRQ)

# /etc/rc.d/rc.wireless ra0
/etc/rc.d/rc.wireless: ra0 is 'Any ESSID'
/etc/rc.d/rc.wireless: /sbin/iwconfig ra0 nick linux
/etc/rc.d/rc.wireless: /sbin/iwconfig ra0 essid default

# iwconfig ra0
ra0 RT61 Wireless ESSID:"default" Nickname:"linux"
Mode:Managed Channel:6 Access Point: xx:xx:xx:xx:xx:xx
Bit Rate=54Mb/s
RTS thr:off Fragment thr:off
Encryption key:off
Link Quality:0/70 Signal level:-209 dBm Noise level:-256 dBm
Rx invalid nwid:0 Rx invalid crypt:0 Rx invalid frag:0
Tx excessive retries:0 Invalid misc:0 Missed beacon:0

#dmesg
...
jueming
jueming
...

# ifconfig ra0 inet 192.168.1.100 up

(The same if
#dhcpcd ra0)

# ifconfig ra0
ra0 Link encap:Ethernet HWaddr xx:xx:xx:xx:xx:xx
inet addr:192.168.1.100 Bcast:192.168.1.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4260 errors:0 dropped:0 overruns:0 frame:0
TX packets:34 errors:0 dropped:0 overruns:0 carrier:0
collisions:4 txqueuelen:1000
RX bytes:320461 (312.9 Kb) TX bytes:504 (504.0 b) (And they are changing)
Interrupt:7 Base address:0xf000

#dmesg
...
jueming
IN=ra0 OUT= MAC=xx:xx:xx:xx:xx:xx:xx:xx:xx:xx:xx:xx SRC=192.168.1.1 DST=224.0.0.1 LEN=28 TOS=0x00 PREC=0x00 TTL=1 ID=0 DF PROTO=2 (these are from iptables firewall)
jueming
...


# ping 192.168.1.1
PING 192.168.1.1 (192.168.1.1) 56(84) bytes of data.
From 192.168.1.100 icmp_seq=1 Destination Port Unreachable
ping: sendmsg: Operation not permitted

(The same if:
#route add default gw 192.168.1.1)

I found the problem with rt61 - it was iptables firewall rule. Now everything works just perfect with the latest wireless MIMO technology with extended verticat distance.

Greetings.

Примен се получава следният праблем ползвам Wireless network с rt2500 card. Под Уиндовс интернета си върви нормално, но когато мина на линукс започват ограниченията. Неможе да открие една голяма част от съществуващи сървъри по света    Сменях драйвърите, но пак си е същото. Когато му скимне отваря сайтовете. Незнам каква може да е причината - от доставчика или някои портове....