aa nachi iztrih si bez da iskam toq file 
deto se namira v c:\peanut . t.e linux.bat
ako moje nqkoi da mi kaje kakvo e negovoto sadarjanie 
che da si go sazdam :)
mersi
:)

Predpolagam che e neshto to tozi sort:
loadlin bzimage root=/dev/hdaX ro 
 kudeto bzimage e iadroto, mozhe da e vmlinuz ili neshto ot
sorta.
 root=/dev/hdaX  mu ukazva na koi dial da se polzva za root na
linuksa.

Eto ti go bukvalno:

@echo off
rem Peanut Linux
 rem
==========================================================================+
loadlin vmlinuz root=/dev/hda5 ro
 rem                                                         
                 |
 rem For High Resolution add [vga=ask] to the end of your
"loadlin" above.     |
 rem For  CD-R/W  add  [hdb=ide-scsi]  to the end of your
"loadlin" above.     |
 rem Type these command(s) if your not sure about partitions,
etc.:            |
 rem # dmesg                                                 
                 |
 rem # fdisk -l                                              
                 |
 rem # cat /proc/partitions                                  
                 |
 rem # parted /dev/xxx print  <e.g. where device xxx is
either "hda" or "sda"  |
 rem HOW TO MAKE A TWO 1.44 FLOPPY BOOT/ROOT/RESCUE DISK SET 
 (recommended).  |
 rem Boot with 'ram.bat', press <Enter> to login and type
these 2 lines below: |
 rem # mount /dev/xxxx /DOS  <where xxxx can be:  "hda[1-20]"
or "sda[1-20]"   |
 rem # floppy (or run 'setup' and chose "re-config" then
[Floppy Boot/Rescue]  |
 rem TIP. You can run DOS/WIN defrag on the UMSDOS
partition(s) without harm.  |
 rem TIP. if  /dev/hda1 is not where your x:\peanut:
directory is, then type   |
 rem in the actual device, i.e. /dev/hda2, /dev/hdb1,
/dev/sda[1-20] for SCSI. |
 rem Then type >>> mc <<< for Midnight Commander and go nutz.
             |
 rem
==========================================================================+
rem

 Zamesti '/dev/hda5' s tochniia put do diala/ustroistvoto s
Peanut