imam slackware 8.1 s iadro 2.4.18
na nego sa zakacheni 3 mrezovi karti 
 Kingston Fast EtheRx KNE111TX PCI 10/100 Fast Ethernet
Adapter
raboteshti  s draiver tulip, koito si idva sus slackware.
Kartite se razpoznavat i instalirat pravilno spored men:
ifconfig:

eth0      Link encap:Ethernet  HWaddr 00:C0:F0:7A:40:2F
           inet addr:193.68.23.3  Bcast:193.68.23.31 
Mask:255.255.255.224
           UP BROADCAST RUNNING MULTICAST  MTU:1500 
Metric:1
           RX packets:19 errors:0 dropped:0 overruns:0
frame:0
           TX packets:34 errors:106 dropped:0 overruns:0
carrier:105
          collisions:0 txqueuelen:100
          RX bytes:1879 (1.8 Kb)  TX bytes:1428 (1.3 Kb)
          Interrupt:12 Base address:0xc000

eth1      Link encap:Ethernet  HWaddr 00:C0:F0:7A:1B:E1
           inet addr:192.9.210.149  Bcast:192.9.210.255 
Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST  MTU:1500 
Metric:1
           RX packets:235 errors:0 dropped:0 overruns:0
frame:0
           TX packets:129 errors:12 dropped:0 overruns:0
carrier:24
          collisions:0 txqueuelen:100
           RX bytes:19724 (19.2 Kb)  TX bytes:14317 (13.9
Kb)
          Interrupt:10 Base address:0xc400

eth2      Link encap:Ethernet  HWaddr 00:C0:F0:7A:40:39
           inet addr:192.168.0.1  Bcast:192.168.0.255 
Mask:255.255.255.0
           UP BROADCAST RUNNING MULTICAST  MTU:1500 
Metric:1
           RX packets:0 errors:0 dropped:0 overruns:0
frame:0
           TX packets:0 errors:0 dropped:0 overruns:0
carrier:0
          collisions:0 txqueuelen:100
          RX bytes:0 (0.0 b)  TX bytes:0 (0.0 b)
          Interrupt:11 Base address:0xc800

lo        Link encap:Local Loopback
          inet addr:127.0.0.1  Mask:255.0.0.0
          UP LOOPBACK RUNNING  MTU:16436  Metric:1
           RX packets:56 errors:0 dropped:0 overruns:0
frame:0
           TX packets:56 errors:0 dropped:0 overruns:0
carrier:0
          collisions:0 txqueuelen:0
          RX bytes:5448 (5.3 Kb)  TX bytes:5448 (5.3 Kb)

route:

Kernel IP routing table
 Destination     Gateway         Genmask         Flags Metric
Ref    Use Iface
 193.68.23.0     *               255.255.255.224 U     0     
0        0 eth0
 localnet        *               255.255.255.0   U     0     
0        0 eth1
 192.168.0.0     *               255.255.255.0   U     0     
0        0 eth2
 loopback        *               255.0.0.0       U     0     
0        0 lo
 default         193.68.23.3     0.0.0.0         UG    1     
0        0 eth0


eth0 e svurzan kum cisco wireless bridge Cisco WGB340 V8.65
 eth1 e svurzan kum switch za lokalna mreza (raboti bez
problemi)
eth2 e svoboden zasega

 problemut e che ping-vam uspeshno vsichki ip na mrezovite
 karti, moga da napravia traceroute kum ip na eth1 a
traceroute kum ip 
na eth0 i eth2 uvisva.
 moga da ping bridge , svurzan kum eth0, no ne i otsreshtnata
strana na wireless vruzkata

 Imam sushtata konfiguracija na redhat 7.1 , koiato raboti
bez problem , wireless vruzkata si e OK

Niamam nikakva ideja kakuv moze da e problema
Molia pomognete

 Iavno default gateway-a e prez eth1 i poneje niamash routing
 protokol, koito da okazva koi trafik ot kade da mine,
 vsichko se preprashta kam eth1, ama tam gateway-a neznae kak
 da stigne do IP-tata ot drugata strana na eth0 i eth2,
zatova i tracerout-a uvisva.
 Triabva da pusnesh niakakv routing protokol na taia mashina
 (RIP shte ti e nai-lesno, ima si go po default vav vseki
 *nix), za da e iasno koe ot kade da minava. Misli za
mashinata si kato za router.

 hmm neznam za RIP ... ako e v1 na RIP - toi e classfull i ne
 poddurja CIDR t.e. routing table-ite ne se sudurjat nikakva
informacia za subnet maskite na mrejite
ako e v2 RIP - niama problemi :) 
 
niama li da stane po-dobre sus statichen route - 
route add -net .....

kaji ako reshish po niakakuv nachin problema :)

 Suzeliavam che vi zagubih vremete ama problema beshe suvsem
drug - v nastroikata na wireless bridge 
blagodaria za otgovorite