Accessing the Network Through the
Embedded PPP Dial-Up Software on the
Device
If you select this method for accessing the network, the HG530 starts to set up
a dial-up connection automatically after the startup. You can access the
network after you power on your computer. You do not need to install any
special dial-up software on your computer or perform dial-up operations on
your computer. To configure the HG530 and your computer for the network
access, do as follows:
1. Log in to the Web-based configuration utility of the HG530.
1) Launch the Internet Explorer on your computer.
2) Enter 192.168.1.1 in the address bar, and then press Enter.
3) In the displayed dialog box, enter the user name and the password, and
then click OK.
By default, the user name is admin and the password is admin. After the
user name and the password are verified, you can access the Web-based
configuration utility.
2. Enable the embedded dial-up function.
1) In the navigation tree on the left of the Web-based configuration utility,
choose Basic > WAN Setting.
2) Select a PVC number, such as 1, from the PVC drop-down combo box.
3) Enter the VPI and VCI that are provided by the network operator in the
VPI and VCI text boxes.
4) Select Yes from the Active drop-down combo box and select Routing
from the Mode drop-down combo box.
5) Select PPPoE from the Encapsulation drop-down combo box.
6) Enter the user name and password that are provided by the network
operator in the Username and Password text boxes, and keep the
default settings of other parameters.
7) Click Submit to save the settings.
After you complete the preceding settings, you can surf the Internet.
You need to perform the preceding operations on a computer once only. The
next time when you power on your computer, you can surf the Internet without
any configuration...
лесно е пишеш в гоогал Huawey HG530 и втория линк пдф ти е юзър гайда
а да ресетни го ако е бил отварян за всеки слачай
